WANTED ITWAMP - Mitre Mite Stand & Support Table

[John Barlowe]

ISO: the floor stand and wooden support table (hardware) for a VN2+1 underpinner. I am getting a quote on a new one but would prefer to find a used one if the price is right - come on downnnnnnn, let's make a deal.

 

[John Barlowe]

Well, I got a price on a new stand - support table hardware - table. I guess I will not be buying new, as I have seen that setup sell with the v-nailer used for less than they want.

Still hoping someone has some of this used (especially the support table hardware). If not I guess I'll figure out how to build what I need. Just wanted to save some time on this project.

 

[Gregory K. Norris CPF]

John, I'll be at Mayne Framing Supply's open house next weekend. I'll look around the warehouse. They don't promote it, but they sell a lot of used equipment. I wouldn't be at all surprised to find one there. They sell at fair prices, so if it is there, I might be able to get it at a good price. It is their 35th anniversary and they are always in a festive mood at one of these things. PM me with the highest you would want to go.

If you want to talk to them directly and see what they have, you can find contact info at Mayneframing.com. They don't usually post anything used on their website.

 

[John Barlowe]

Faced with the cost of a new stand / table, I decided to just build my own. All in it was only about $150.00, I found a closeout deal on a tool cabinet for $89.00 and one sheet of 3/4" plywood for $45.00.

 

[Gregory K. Norris CPF]

Yours looks better than the factory model and has storage!

 

[Robin Gentry MCPF]

Nice!

 

[Randy Parrish CPF]

I would much rather have that, than the factory stand.