Mark Schaefer
Participant
Does anyone out there have some extra blade holders for the Fletcher 2100 or 2200 Mat Cutter? If you have some extra you are willing to sell, I am interested.
-
Welcome to the Framer's Corner Forum, hosted by the Professional Picture Framers Association. (PPFA)
You will have to register a free account, before you can SEARCH or access the system. If you have already registered, please LOG IN
If you have already registered, but can't remember your password, CLICK HERE to reset it.
WANTED Blade Holders for Fletcher 2100 Mat Cutter
- Thread starter Mark Schaefer
- Start date
order part #[FONT="]12-542 from f;etcher-terry[/FONT]
Hi Mark,
The F-2100 came with two blade holders that were interchangeable, while the F-2200 came with only one on the bevel side that is of the same design. The straight magazine holder is unique on the F-2200. Regardless, the 2 or 1 with each machine, means that seldom would a framer depart with them unless the machine was being trashed, in which case it is unlikely that the magazines would be in pristine condition.
As Cliff suggested, I would recommend contacting Fletcher-Terry directly to order additional magazines.
Years ago, a German museum ordered about 3-4 extra blade magazines, so that each could be calibrated to a unique depth. They actually applied a small amount of lock-tite on the blade adjustment screw at the rear so that once set, other users would not mess with the settings! :sneakiness:
I am guessing that this is a similar motive for you, or perhaps you acquired a used machine where the magazines went missing?
Regards,
John
The F-2100 came with two blade holders that were interchangeable, while the F-2200 came with only one on the bevel side that is of the same design. The straight magazine holder is unique on the F-2200. Regardless, the 2 or 1 with each machine, means that seldom would a framer depart with them unless the machine was being trashed, in which case it is unlikely that the magazines would be in pristine condition.
As Cliff suggested, I would recommend contacting Fletcher-Terry directly to order additional magazines.
Years ago, a German museum ordered about 3-4 extra blade magazines, so that each could be calibrated to a unique depth. They actually applied a small amount of lock-tite on the blade adjustment screw at the rear so that once set, other users would not mess with the settings! :sneakiness:
I am guessing that this is a similar motive for you, or perhaps you acquired a used machine where the magazines went missing?
Regards,
John
